Work
The work behind the result.
Selected fitting, build, retrofit and refinement work showing the decisions, specifications and processes behind the finished equipment.
Measured. Built. Verified.
How ASUBURE documents work
More than finished-club photographs.
A completed club can look good without showing why it was built or changed that way.
Where useful, ASUBURE documents the work behind a project — what needed to be addressed, what was measured, what decision was made, what work was completed, and how the final specification was verified.
Not every project requires every section.
- 01The requestWhat needed to be addressed?
- 02The baseline / findingsWhat did the relevant measurements or evaluation show?
- 03The decisionKeep · Refine · Retrofit · Build
- 04The specificationWhat was selected or defined?
- 05The workWhat was actually done?
- 06The verificationWas the completed equipment checked against the intended specification?
- 07The resultWhat was ultimately delivered or recommended?
Types of work
Four honest categories
- FitEquipment evaluation that may lead to Keep, Refine, Retrofit or Build.
- BuildNew equipment built to a defined specification.
- RetrofitExisting equipment substantially rebuilt while retaining a suitable major component.
- RefineExisting equipment measured, adjusted, repaired, optimized or verified.
Documented project
Complete Set Build
TaylorMade Qi Max · Qi4D Max
A complete custom set requiring different shaft families across driver, fairway wood, hybrid and irons while maintaining intentional specifications and progression throughout the equipment.
- DriverTaylorMade Qi4D Max / KBS PGW
- Fairway WoodTaylorMade Qi4D Max / KBS PGW
- HybridTaylorMade Qi4D Max / KBS Tour Graphite Prototype
- IronsTaylorMade Qi Max / KBS $-Taper Lite
- Finishingpersonalized ferrules and coordinated grips
Relevant components were prepared and assembled with attention to specification, flex and progression across the set.
Different clubs require different components and specifications, but the relationships through the set should remain intentional.
- Playing length
- Shaft characteristics
- Frequency / flex
- Component weight
- Total weight
- Swingweight
The objective isn’t to make every club the same. It’s to make the differences intentional.
The completed equipment was checked against the intended build specifications before collection.
Full case study coming soon
A detailed write-up of this build will be published when the complete project record and any required permissions are available.
Verification philosophy
Assembly finishes the club. Verification finishes the build.
Depending on the project, final checks may include playing length, swingweight, total weight, frequency, loft, lie, relevant set progression and visual/assembly inspection.
Not every measurement applies to every project.
Case study principle
Real work only.
ASUBURE does not publish invented fitting results or fabricated case studies.
Projects are documented when there is useful work to show and when customer information can be shared appropriately.
Customer identity should remain anonymous by default unless permission has been obtained.
Future project types
What may be documented next
Future documented work may include examples such as:
- KeepFitting where no equipment change is recommended
- RefineSpecification correction or set evaluation
- RetrofitRetained component + specification-driven rebuild
- BuildNew custom equipment
These are future possibilities, not fabricated examples.
Have a build or equipment question in mind?
Already have components, an external fitting specification, an existing club you want evaluated, or simply something you want to improve?
Tell ASUBURE what you’re working with.